Ways in Which Water Booster Pumps Are Used
It is necessary to install a high-pressure water supply system if you want it to cover longer distances. Similarly, cyclical water systems where water moves in a loop experience instances where the pressure in the system falls below a certain minimum value. This is where the idea of a booster pump system to supply the extra pressure comes in handy. Water booster pumps are used for a variety of applications that are listed below.
When the Area Supplied By the System is Large
Gates valves and pipes are some of the components along which water flows in a water supply system. The water in the pipes experiences frictional force that tends to oppose its flow. Frictional force is usually greatest if the water has a longer distance to cover along the pipes. The implication is that there’s a significant reduction in the pressure of the water. Due to this phenomenon, there’s need to inject in some extra pressure to ensure that the water reaches its intended endpoint. This is accomplished by installing booster pumps at certain points in the system.
Pumping Form Deep Wells
Sometimes it is necessary to pump water from wells that are very deep. This often happens when sinking boreholes in relatively dry areas that have low water tables. The system installed over such a well will require very high pressure to draw water against gravity. And due to the fact that there may not be sufficient pressure in one pump to accomplish the task, the system will require incorporation of booster pumps along its length to supplement the primary pumps.
Pumping System with a Varied Load
Municipal water supply systems have to deal with varying demands for water from their clients. In the course of a single day, different people will require various amounts of water for their use. The result is off-peak hours where demand is low and peak hours where demand for water spikes. Peak consumption rate is hardly the parameter to use when setting up a supply system since this would mean losses for the company. A viable alternative is to set up the off-peak supply system and then have it supplemented by the booster pump system during the peak hours. Doing so guarantees that the system operates optimally regardless of the prevailing conditions.
Pumping and Disposal of Sewage Waste.
There usually exists constant fluctuation in the viscosity of sewage waste handled by the municipal waste management. To prevent the blockage of the piping system, more pressure is usually required to pump human waste with higher viscosity than that with a lower viscosity. The system will therefore need to be designed with the normal flow in mind, then a separate booster pump system put on standby for those instances when the flow will be extra thick.